Qinhuangdao billiards table brand xin crown remind you how to identify the quality of billiards table?

　　Identify the quality of the billiard table hasThree key points: one look, two touch, three listen.

　　A look:

　　1) Look at the appearance. A good table is beautiful in shape, fine in work and elegant in paint. It matches bright colored balls and velvety green, just like a precious handicraft. Inferior ball table rough workmanship, dark paint, give a person a kind of uncomfortable feeling.

　　2) Look at the work. The workmanship of the high-grade ball table is fine, horizontal, flat and vertical, and each connecting part fits perfectly. The paint is flat as a mirror and feels smooth and delicate. In addition, hit the edge of the library with a slight force from the waist to see if the ball placed on the table is shaking. The smaller the shaking, the better. The immovable table indicates that the wood used is hard and well-made.

　　(3) Look at the edge of the library. Look at whether there is any gap in the contact part between the library edge and the table top. When the library edge is deformed, it is usually a middle drum or both sides are tilted upward. If the gap is small and can't be seen clearly, you can try to insert the bank card you carry with you to the bottom of the library edge, so that it is better not to insert it. Squatting at one end of the library edge to see if the rubber edges of the two library edges are in a straight line; See if the library edge is parallel to the table top, and see if the rubber edge is up or down.

　　(4) Look at the mouth of the bag. Take the slate circle under the bag mouth as the center to see whether the arcs on both sides of the library are symmetrical, and whether the edge curves of a single arc are smooth and consistent. Look at the table at the mouth of the bag for folds, especially the middle bag. See if the leather bag at the mouth is flat and if the gap between the edge and the edge of the library is too large. Shake the bag mouth up and down with your hand to see if it is loose. Hit the cue ball vigorously with the middle shot to see if the target ball spits when it hollows into the pocket.

　　5) Look at the ball. Let the ball roll on the table to see if the speed is even, if the line changes, and if it shakes left and right when it is about to stop. A good ball is as smooth as flowing water, as if it's not rolling, as if it's sliding on ice.

　　(6) look at the elastic. Throw with your hand or hit with a club vigorously, and watch the number of rebounds of the ball on the long or short side of the table to determine the magnitude of the elasticity. It is appropriate to use 4 warehouses to 4 warehouses and a half for the long side and 4 warehouses and a half to 5 warehouses for the short side. Another identification method is: use the club to hit the ball vigorously to the middle of the second library edge close to the top bag on the right, and the hit ball can be folded into more than 6 libraries.

　　(7) Look at the slate. Look at whether the surface of the slate is smooth, whether there are thick white lines, large patterns, sand holes, hard beans, rust, cracks, artificial repair and other defects.

　　(8) Look flat. Look at whether the putty at the joint of the countertop slate is a thin line equal to the thickness of the joint or an intermittent wide band. The wide putty indicates that one of the two slates is low or partially uneven.

　　On the adjusted level of the slate table, gently push the cue ball with a club to make it roll at a speed of 0.2M/sec in the longitudinal, transverse and oblique directions, with the same line as well.

　　On the table with the laid tabletop, push the cue ball lightly with the force close to but not touching the edge of the library in the straight line direction along the wool and against the wool, preferably with the same line. In the direction of the reverse wool diagonal line, push gently with the force that the cue ball does not fall into the bag mouth. It is better to change the line slightly when the bottom bag is opposite to the bottom bag. It is better to change the line no more than one ball.

　　(9) Look straight. Put four or five balls on the edge of the library near the bottom bag so that they are closely attached to each other and the edge of the library, and then hit the ball on the right with the right hand, so that the ball hit on the left will roll to the bottom bag along the edge of the library, and it is better to be able to enter the bag under moderate strength. This method can see the flatness of the slate and the straightness of the library edge.

　　(10) Look at the fire board. Most of the library edge of the ball table in the ball room is decorated with fire-proof board. Good craftsmanship looks like paint from a distance, and looks flat like a mirror from a close distance. There is no bubbling or collapse.

　　(11) Look at the paint film. Look at whether the paint upper surface hit by the ball is a deep pit or a white shallow point. If the shallow point indicates that the upper surface wood has high hardness, and the fully enclosed paint film is thick and hard.

　　Second touch:

　　(1) Touch the wooden frame. Touch the bolt holes at the edge of the wooden frame and library with your fingers. If you feel that the hole wall is rough or the wood fiber is overwhelmed by the hole opener, it is soft wood, and the hole wall is smooth and without burrs is hard wood or density board. Touch the back of the wooden frame with your hand to see if it is a plywood cladding, and if so, it is made of low-grade broken wood inside.

　　(2) Touch the table. Touching with the palm of your hand in the direction of the top warehouse is like touching Hu Zha Zi. Most of them are imported Taiwan with straight hair (domestic imitation imported Taiwan also has this feeling). Touching in the direction of the bottom warehouse is more delicate, smoother and smoother. This is also the main method to identify high and medium-grade imported Taiwan and domestic Taiwan.

　　(3) Touch the edge of the library. Use four fingers to touch the inclined part of the rubber strip along the longitudinal direction, so as not to feel obvious waves. The obvious wave leng shows that the pulling force on the bag help table is different.

　　Three listening:

　　(1) Listen to the slate. Tap the slate table with the ball gently, and there will be a clear murky sound different from that of other places where there is a interlayer. (When there is a station, knock it lightly to prevent it from going out of the pit)

　　(2) Listen to the library. Hit the edge of the library with a medium-strength hand throwing ball. Listen to the sound of hitting the edge of the library. It is better to make a real sound similar to "stepping" with a small sound. If there is an empty sound of "bang bang" or "bang bang", it means that the edge of the library is soft, the work is poor or the edge of the library is loose. It is better to hit different parts of the whole library edge with the same sound.

　　(3) Listen to the bag. There is a sound when hitting the ball into the bag. Of course, the louder the sound is, the sound is crisp.

When you have mastered the above knowledge and then identify the quality of the billiard table, you will not be at a loss, you will be able to know what to do, and you will not distinguish between good and bad.